top of page
Maximum Build Dimensions
"Smart" Extruder Properties
Lenght - 11 in (27.9 cm)
Width - 6 in (15.2 cm)
Height - 5.9 in (14.9 cm)
Nozzel Diameter - 0.015in (0.4 mm)
Layer Height (Z) - 0.0039 in (0.1mm)
Coordinate System
Althought your design can be reoriented,
it is recomended that you design with the Z axis in the orientation shown.
Support Material
Support Material will be automaticallt generated for overhangs greater than 65 degrees. This can sometimes be dificult to remove. You can find tequniques in the Best Practices section to eliminate the need for support material.
bottom of page